DOD SR400D Spezifikationen PDF herunterladen (Seite 63)

 c. Connect the outer pesticide feed line to the base

of the tank, along the top of the discharge tube,

through the inline cutoff valve, to the nozzle.

 d. With the engine off, (remember that the pesticide

flow is gravity fed), examine the system for leaks

by adding approximately 1 quart of water to the

tank and opening the inline flow valve, located

midway along the discharge tube, and the

volume control cock located on top of the nozzle.

Tighten all leaking areas as required and then

drain any remaining water from the system. BE

SURE TO PURGE THE WATER FROM THE

PESTICIDE LINE.

SET-UP PROCEDURES FOR ULV OPERATIONS

To conduct ULV operations, you must purchase a special

ULV nozzle system.

 2. a. Set up the unit into the mist spray configuration

as described above.

 b. Remove the mist spray nozzle and replace it with

the ULV nozzle and slide bar.

 c. Ensure that the ULV pesticide volume control

knob is in the off position.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 243 244

Keine Kommentare

DOD SR400D Spezifikationen Seite 63