DOD SR400D Spezifikationen PDF herunterladen (Seite 139)

131

 3. Check the engine Oil Level using the dipstick

located on left side of engine below the Air Filter (It

is marked “Oil”). Add SAE 30-weight detergent oil

as needed.

 4. Check the Blower Oil level. The plug is located on

the side closest to the drain plug. Fill through the

Breather Plug at the top, until the oil runs out of the

overflow hole at the side of the blower; close with

plug. You must use 40-weight NON-DETERGENT

oil as needed.

 5. Periodically grease the two fittings, located on

Blower behind the engine.

 6. Check the battery water level. Add water to the

proper level. Periodically, charge the battery.

 7. Ensure that the sprayer Battery Cables are clean

and tight.

 8. Check the Flushing Solution level in the one-gallon

tank mounted on the Formulation Tank bracket and

fill the tank with an approved flushing solution.

Diesel fuel or transmission fluid can be used as

alternatives.

 9. Close the Choke located under the Air Filter

Housing (front of engine) by pulling out the ring.

Omit this step if engine is warm.

 10. Note: OPEN Choke as needed AFTER engine

starts.

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 243 244

Keine Kommentare

DOD SR400D Spezifikationen Seite 139