DOD SR400D Spezifikationen PDF herunterladen (Seite 11)

 8. Select the required nozzle and screw onto the tip

of the wand. If using a Multi-jet nozzle, loosen the

retaining collar on the nozzle and rotate it to the

desired setting, making sure that the aperture is

directly over the pesticide exit hole in the wand.

 9. Check for proper pressurization and the possibility

of leaks in the system by adding water to the tank.

Leave approximately 1/3 of the tank empty for air.

 10. Replace the rod/piston assembly to the cylinder by

placing the piston cup at a 45-degree angle and

pushing the piston gently into the cylinder. Ensure

that the piston cup does not crimp or buckle or a

good seal will not develop.

 11. To properly pressurize the tank, pump the unit 6-10

times. Depress the trigger on the wand. Check for

water and air leaks in the tubing and various seals.

OPERATING PROCEDURES

 12. Discontinue spraying the water and SLOWLY twist

the handle to allow the pressurized air to escape.

 13. Remove the cylinder and dump out the water.

 14. Put on all personal protective gear.

 15. Calculate the exact amount of pesticide

concentrate required for the operation.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 243 244

Keine Kommentare

DOD SR400D Spezifikationen Seite 11