DOD SR400D Spezifikationen PDF herunterladen (Seite 100)

CLEANING

 10. After spraying, clean the tank thoroughly. If some

spray liquid is left inside, drain tank completely.

 11. Pumping causes air to be taken in and the remaining

liquid to be discharged. Pump until liquid and air are

coming out through the nozzle.

 12. Refill tank with a few quarts of clean water and

pump the water out as explained above (if

necessary, repeat this procedure several times).

 13. If the shut-off valve is removed, the pump can be

flushed quickly. Improper spray distribution is the

result of a clogged nozzle, which is easily removed

and cleaned.

 14. Soap and water may also be used to clean tank. Do

not use aggressive cleaning agents or abrasives.

Follow the recommendations of the chemical

manufacturer for disposal of waste-water and

chemicals. Activated charcoal in liquid or other form

may be used to absorb chemicals in tanks or spills.

MAINTENANCE AND STORAGE

 15. Refill To protect the piston, cylinder and Viton®

collar, a fine mesh, stainless steel screen is located

on the pressure cylinder inlet. If you find that your

sprayer will not empty the formula tank, check for a

clogged inlet screen (Fig. 45). The inlet screen is

located at the bottom of the pressure cylinder on the

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 243 244

Keine Kommentare

DOD SR400D Spezifikationen Seite 100